Development and application of ultrasound technology for treatment of organic pollutants

The necessity of cost effective, environmentally friendly technology has become increasingly important to remediate persistent organic pollutants in the environment. The emerging greener ultrasound technology has the potential to serve the remediation industry. In this study, the use of low power, high frequency (HF) ultrasound (1.6 MHz, 145 W/L) has been shown to effectively remediate DDT (90% of 8 mg/L) in water and sand slurries. Addition of iron powder accelerated DDT degradation in the sand slurry under ultrasonication. The potential of HF ultrasound (1.6 MHz, 160 W/L) in degradation of the non-volatile, polar model compound methylene blue (MB) was studied in MB spiked demineralised water and wastewater. A 70 % of 0.4 mg/L of MB was degraded in demineralised water whereas only 54% of MB degraded in MB spiked wastewater. There was a decrease in MB degradation rate with an increase in MB concentration. High power, low frequency (LF) ultrasound (20 kHz, 932 W/L) was used to desorb 400 mg/L of DDT added to three different natural soil slurries at 5, 10, 15 and 20 wt. % each. Each soil slurry was prepared in 0.1% v/v SDS surfactant solution, soaked for 30 min. and heated for another 30 min. at 40 oC before sonication. For the neutral pH soil slurry with higher dissolved organic carbon, the desorption efficiency achieved was over 80% in 30 s sonication. Alkaline soil with higher surface area than neutral soil indicated 60% desorption efficiency while the acidic soil, with the highest surface area and a higher amount of non-soluble organic matter, yielded 30% desorption efficiency under similar desorption conditions. Coconut fibre, used to biosorb the desorbed DDT in the decanted solution, was found to have over 25 g/kg of biosorption capacity for DDT. The surfactant SDS and associated DDT were completely separated from decanted liquid of the desorbed slurry with alum using adsorptive micellar flocculation in 60 min. settling. Acidic pH and molar concentration ratio of Al3+/SDS = 0.5 was used to completely remove the DDT. Using 20 kHz, 1125 W/L of sonication in an 80 mL reactor with air saturated 50 mg/L DDT at 20oC, the DDT removal efficiency achieved was 80% in 20 min. With zero valent iron addition, DDT removal efficiency in 15 min. is 100% with 15 and 22 mg/L of initial DDT concentrations. The settled DDT slurrywas remediated using 20 kHz at 240 W/L achieving DDT removal efficiency of 87% in 15 min. Also LF ultrasound was found to be effective in remediating chloroform (8 mg/L in 60 min) from spiked demineralised water and contaminated groundwater in both batch (120 W/L) and flow cell (6000 W/L) modes. Modeling and simulation of the ultrasonic reactor under 20 kHz ultrasonication was performed for various shape reactors using commercially available software. For almost all reactors, the highest ultrasonic intensity was observed near the transducer???s vibrating area. It was found that the highest acoustic pressure distribution, which is critical to the performance of the reactor, occurred in the conical reactor and flow cell configuration.

Thesis (PhD)--University of South Australia, 2010